![]() ![]() I see, I thought you've reset the controllers before re-doing the pairing. The very first time I started after a os install it prompted and i setup the controller with usb. Pressed ok,went back to menu - removed cable - nothing said in Problem connecting a bluetooth ps3 controller: Please repair duel shock to continue or disregard. Now I get a message saying "PS3 driver temporarily interupted in order to allow compatibility with standard BT periferals. I removed the registered BT device and re-registered this time choosing the first device option (that was all mac adress looking, not the one that said ps3 controller). ![]() On reboot the controller works fine with cable but nothing if I remove it. Pulled the power cable to reboot with controller attached via cable. Turned it back on, all lights flashed for a moment and then 1 steady on.Ĭonnected the usb cable - still noting works I help teh PS button down - nothing until it turned off. I removed the usb cable - nothing works although now the ctrl leds arnt all flashing, theres just one steady on which I assume means it connected. Got a message saying successful authentication, you can now remove the usb cable (never seen this before). The second option was a mac like address followed by "playstation controller" ![]() This time I was given an option of 2 devices (never had that before) One was just numbers and letters like a mac addres. With the cable connected I checked for paired BT devices - none found Installed clone support gasia (fairly sure my controller is gasia, saw it a few times in messages while iv been messing about). I then uninstalled sixaxis and installed ps3controller With cable still attached I then went to bluetooth - register deviceĭisconnected teh cable, pressed the ps button and re-connected the cable Oookay.on a fresh OS install, with the PS3 controller attached via usb I setup the controller I removed the bluetooth device and tried to start from scratch and now it wont even connect teh device :( Through multiple removing and reconnecting I saw a message saying "duel shock, disconnect controller press ps button then reconnect" - so I attached the usb and did this and I then went to configure the controller which went fine and it worked - with teh usb cable attached. I read on another thread that I dont need to bothere with that bit and so long as the device is registered I can just config the controller which doesnt seem to be the case. During the "register and connect" I have connected the device and I then go to a section about security and any option I choose just seems to do nothing but freeze. USB devices - wifi dongle for a keyboard - Dragon Shock 3rd party PS3 controller (bluetooth).īut Im still having trouble. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |